Insulin Receptor ELISA Kit

Produktnummer ABIN7012860

Produktdetails Insulin Receptor ELISA Kit

Target: Insulin Receptor (INSR)

Reaktivität: Maus

Nachweismethode: Colorimetric

Methodentyp: Sandwich ELISA

Detektionsbereich: 0.312 ng/mL - 20 ng/mL

Untere Nachweisgrenze: 0.312 ng/mL

Applikation: ELISA

Verwendungszweck: The kit is a small sample sandwich enzyme immunoassay for in vitro quantitative measurement in various sample types.

Proben: Cell Culture Supernatant, Cell Lysate, Plasma, Serum, Tissue Homogenate

Analytische Methode: Quantitative

Spezifität: This assay has high sensitivity and excellent specificity for detection of Insulin Receptor.

Sensitivität: 0.117 ng/mL

Güteklasse: Small Sample

Bestandteile:

• Pre-coated, ready to use 96-well strip plate, flat buttom
• Plate sealer for 96 wells
• Reference Standard
• Standard Diluent
• Detection Reagent A
• Detection Reagent B
• Assay Diluent A
• Assay Diluent B
• Reagent Diluent (if Detection Reagent is lyophilized)
• TMB Substrate
• Stop Solution
• Wash Buffer (30 x concentrate)
• Instruction manual

Anwendungsinformationen

Probenmenge: 25 μL

Testdauer: 3 h

Plattentyp: Pre-coated

Protokoll:

1. Prepare all reagents, samples and standards,
2. Add 25μL standard or sample to each well. Incubate 1 hours at 37 °C,
3. Aspirate and add 25μL prepared Detection Reagent A. Incubate 1 hour at 37 °C,
4. Aspirate and wash 3 times,
5. Add 25μL prepared Detection Reagent B. Incubate 30 minutes at 37 °C,
6. Aspirate and wash 5 times,
7. Add 25μL Substrate Solution. Incubate 10-20 minutes at 37 °C,
8. Add 20μL Stop Solution. Read at 450nm immediately.

Aufbereitung der Reagenzien:

1. Bring all kit components and samples to room temperature (18-25 °C) before use. If the kit will not be used up in one time, please only take out strips and reagents for present experiment, and leave the remaining strips and reagents in required condition.
2. Standard - Reconstitute the Standard with 0.5 mL of Standard Diluent, keep for 10 minutes at room temperature, shake gently (not to foam). The concentration of the standard in the stock solution is 20ng/mL. Prepare 7 tubes containing 0.25 mL Standard Diluent and produce a double dilution series by transferring 250 µL each. Mix each tube thoroughly before the next transfer. Set up 7 points of diluted standard such as 20ng/mL, 10ng/mL, 5ng/mL, 2.5ng/mL, 1.25ng/mL, 0.625ng/mL, 0.312ng/mL, and the last microcentrifuge tube with Standard Diluent is the blank as 0ng/mL.
3. Detection Reagent A and Detection Reagent B - If lyophilized reconstitute the Detection Reagent A with 150μL of Reagent Diluent, keep for 10 minutes at room temperature, shake gently (not to foam). Briefly spin or centrifuge the stockDetection A and Detection B before use. Dilute them to the working concentration 100-fold with Assay Diluent A and B, respectively.
4. Wash Solution - Dilute 10 mL of Wash Solution concentrate (30x) with 290 mL of deionized or distilled water to prepare 300 mL of Wash Solution (1x).
5. TMB substrate - Aspirate the needed dosage of the solution with sterilized tips and do not dump the residual solution into the vial again.

Note:

1. Making serial dilution in the wells directly is not permitted.
2. Prepare standard within 15 minutes before assay. Please do not dissolve the reagents at 37 °C directly.
3. Please carefully reconstitute Standards or working Detection Reagent A and B according to the instruction, and avoid foaming and mix gently until the crystals are completely dissolved. To minimize imprecision caused by pipetting, use small volumes and ensure that pipettors are calibrated. It is recommended to suck more than 10μL for once pipetting.
4. The reconstituted Standards, Detection Reagent A and Detection Reagent B can be used only once.
5. Prepare Substrate working Solution within 15 minutes before assay.
6. If crystals have formed in the Wash Solution concentrate (30x), warm to room temperature and mix gently until the crystals are completely dissolved.
7. Contaminated water or container for reagent preparation will influence the detection result.

Aufbereitung der Proben:

• It is recommended to use fresh samples without long storage, otherwise protein degradation and denaturationmay occur in these samples, leading to false results. Samples should therefore be stored for a short periodat 2 - 8 °C or aliquoted at -20 °C (≤1 month) or -80 °C (≤ 3 months). Repeated freeze-thawcycles should be avoided. Prior to assay, the frozen samples should be slowly thawed and centrifuged toremove precipitates.
• If the sample type is not specified in the instructions, a preliminary test is necessary to determinecompatibility with the kit.
• If a lysis buffer is used to prepare tissue homogenates or cell culture supernatant, there is a possibilityof causing a deviation due to the introduced chemical substance.The recommended dilution factor is for reference only.
• Please estimate the concentration of the samples before performing the test. If the values are not in therange of the standard curve, the optimal sample dilution for the particular experiment has to be determined.Samples should then be diluted with PBS (pH =7.0-7.2).

Testpräzision: Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level of target were tested 20 times on one plate, respectively.
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level of target were tested on 3 different plates, 8 replicates in each plate.
CV(%) = SD/meanX100
Intra-Assay: CV < 10%
Inter-Assay: CV < 12%

Beschränkungen: Nur für Forschungszwecke einsetzbar

Handhabung

Lagerung: 4 °C/-20 ° C

Informationen zur Lagerung:

1. For unopened kit: All reagents should be stored according to the labels on the vials. The Standard, Detection Reagent A, Detection Reagent B, and 96-well Strip Plate should be stored at -20 °C upon receipt, while the other reagents should be stored at 4 °C.
2. For opened kits: the remaining reagents must be stored according to the above storage conditions. In addition, please return the unused wells to the foil pouch containing the desiccant and seal the foil pouch with the zipper.

Haltbarkeit: 6 months

Details zu Insulin Receptor

Target: Insulin Receptor (INSR)

Andere Bezeichnung: Insulin Receptor (INSR Produkte)

Synonyme: CD220 ELISA Kit, HHF5 ELISA Kit, 4932439J01Rik ELISA Kit, D630014A15Rik ELISA Kit, IR ELISA Kit, IR-A ELISA Kit, IR-B ELISA Kit, 18402 ELISA Kit, CG18402 ELISA Kit, DIHR ELISA Kit, DILR ELISA Kit, DIR ELISA Kit, DIRH ELISA Kit, DIRbeta ELISA Kit, DInR ELISA Kit, DInr ELISA Kit, Dir-a ELISA Kit, Dir-b ELISA Kit, Dmel\\CG18402 ELISA Kit, INR ELISA Kit, INS ELISA Kit, Inr ELISA Kit, Inr-alpha ELISA Kit, Inr-beta ELISA Kit, InsR ELISA Kit, dINR ELISA Kit, dIR ELISA Kit, dIRH ELISA Kit, dInR ELISA Kit, dInr ELISA Kit, dInsR ELISA Kit, dinr ELISA Kit, dir ELISA Kit, er10 ELISA Kit, inr ELISA Kit, insulin/insulin-like growth factor receptor ELISA Kit, l(3)05545 ELISA Kit, l(3)93Dj ELISA Kit, l(3)er10 ELISA Kit, lnR ELISA Kit, ir-A ELISA Kit, CTK-1 ELISA Kit, ir ELISA Kit, INSR ELISA Kit, NV14476 ELISA Kit, cd220 ELISA Kit, hhf5 ELISA Kit, insulin receptor ELISA Kit, Insulin-like receptor ELISA Kit, insulin receptor L homeolog ELISA Kit, INSR ELISA Kit, Insr ELISA Kit, InR ELISA Kit, LOC100122567 ELISA Kit, LOC100451802 ELISA Kit, insr.L ELISA Kit

Hintergrund: CD220, ISR, HHF5, IR

Pathways: NF-kappaB Signalweg, RTK Signalweg, AMPK Signaling, Carbohydrate Homeostasis, Regulation of Cell Size, Regulation of Carbohydrate Metabolic Process, Growth Factor Binding, Negative Regulation of Transporter Activity